Baumatic B10 Manuel d'utilisateur télécharger pdf (Page 19)

o The brass links must be positioned as marked in the appropriate

diagram and once established ALL terminal screws must be

tightened down firmly.

o If when the hob is first switched on, only two of the zones

work, you should recheck that the terminal screws are all

fully tightened between the links. This should be done

before contacting the Baumatic Service Department.

o IMPORTANT: The appliance must NOT be connected to the

mains supply by means of a 13A plug and socket.

o The cable can be looped if necessary, but make sure that is not

kinked or trapped when the hob is in position. Care must be

taken to avoid the cable being in contact with hot parts of the

appliance.

Replacing the mains supply cable

If the mains supply cable is damaged, then it must be replaced by an

appropriate replacement which can be obtained from the Baumatic

Spares Department.

The mains supply cable should be replaced in accordance with the

following instructions:

o Switch the appliance off at the control switch.

o Open the terminal block on the underside of the hob.

o Unscrew the terminal screws fixing the cable.

o Replace the cable with one of the same length and in accordance

with the specification given above.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Baumatic B10 Manuel d'utilisateur Page 19