Baumatic P75SS Manuel d'utilisateur télécharger pdf (Page 18)

(A) Sealing strip

(B) Clamp

o Place the clamp (B) over the holes that match the size of the

screws. There are one set of screw holes in each corner of the

hob. Slightly tighten a screw (C) through the clamp (B) so that

the clamp is attached to the hob, but so that you can still adjust

the position of it.

o Carefully turn the hob back over and then gently lower it into the

aperture hole that you have cut out.

o On the underneath of the hob, adjust the clamps into a position

that is suitable for your worktop. Then fully tighten the screws

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Pas de commentaire

Baumatic P75SS Manuel d'utilisateur Page 18