Baumatic BDW15 Manuel d'utilisateur

BDW15 60 cm Fully integrated full height dishwasher

Control panel 1) Program indicator neons 2) Program selection button 3) Rinse aid and salt indicator neons 4) ½ load indicator neon 5) ½ loa

Filling with dishwasher salt IMPORTANT: You should only use salt that is specially designed for use in a dishwasher. If any other type of salt is use

o IMPORTANT: You do not need to pour 1 litre of water into the container when you subsequently fill the water softener with salt. Setting the water

Filling with rinse aid The rinse aid is released during the final rinse and it helps to prevent water from forming droplets on your dishes. These dro

o You should continue to adjust the rinse aid level upwards until you get no water spots. o If you get cloudiness or streaking on your dishes, the

Loading the upper basket The upper basket is most suited to washing delicate and light dishware, such as glasses, coffee & tea cups, saucers, pla

Position 2 (lower position) o For accommodating additional tumblers, cups and mugs. You can also place small, espresso sized cups on top of the side

o Deep saucepans should be slanted, to allow water to run off. o The bottom rack has prongs at the rear of the basket that can be folded downwards,

18 1. Forks 2. Soup spoons 3. Dessert spoons 4. Teaspoons 5. Knives 6. Serving spoons 7. Gravy ladle 8. Serving fork IMPOR

The following items are NOT suitable for washing inside a dishwasher:- o Cutlery with a handle of mother-of-pearl, wood, horn or china. o Plasti

USER MANUAL FOR YOUR BAUMATIC BDW15 60 cm Fully integrated full height dishwasher NOTE: This User Instruction Manual contai

Program table Program Cycle Program information Description of cycle Detergent pre/main Normal * For normally soiled loads, such as pots, plates, g

21o Push the top and bottom baskets fully back into position. o Add detergent o Turn the appliance on by using the ON/OFF button. o IMPORTANT:

22At the end of a wash program o The time display will flash for 8 seconds and a buzzer will sound. o If you have used the delay start mode, the

Setting a half load The half load option means that the lower spray arm does not run. IMPORTANT: You should only load items in the upper basket when

o The neon indicates that you need to add dishwasher salt to the appliance. You should follow the procedure outlined on page 11. Cleaning and main

Cleaning the filters For best performance and results, the entire filter assembly should be thoroughly cleaned regularly (ideally after each wash cy

Cleaning the spray arms The spray arms should be cleaned regularly, to prevent hard water deposits from clogging the spray arm jets a

Cleaning the door o To clean the edge around the outside of the door, you should use a soft, damp cloth only. o To prevent water from penetr

E4 o The machine has sensed water in the base. 9 Check that the outlet hose is not kinked or crushed. 9 Check that there are no blockages in the dr

IF THE FAULT CODE REAPPEARS AFTER FOLLOWING THE ABOVE ADVICE AND CLEARING THE FAULT CODE. YOU SHOULD TURN OFF THE APPLIANCE; DISCONNECT THE APPLIANCE

3Contents Environmental note 4 Important safety information 5 – 7 Specifications 8 - 9 Description of the appliance 9 - 1

30Motor hums If the dishwasher is not going to be used for a period of time, then you should make sure that the appliance is set on a wash program o

Dishwasher leaks The rinse aid dispenser is overfilled or rinse aid has been spilt inside the appliance Dishwasher isn’t level Take care not to over

o The aperture that your dishwasher needs to be installed into should resemble the one shown in the drawing on page 31. o There should be less than

o The maximum weight of the furniture door should be 5.5 kilograms. The maximum thickness of the furniture door should be 15 mm. o Use the installa

Adjusting the tension of the door spring o The door of the dishwasher is attached to springs. These are set at the factory to ensure that they are

Connecting to the mains water supply 35ed. IMPORTANT: Do not connect the appliance to your mains water supply using an old or an existing water inl

Connecting to the water outlet 9 Secure the drain hose, so that it cannot move whilst the dishwasher is in use. 9 Place the end of the drain hose

9 Consult the rating plate, located on the right hand side of the drop down door BEFORE making the electrical connections. Ensure that the

o The condensation strip will be located inside of your dishwasher. o Ensure that the underneath of the worktop is clean before sticking the strip

Levelling the appliance o IMPORTANT: Your dishwasher must be level for it to operate properly. o Make sure that the dishwasher is supported whils

ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles

40Securing the dishwasher o The dishwasher must be secured to the worktop, this can be done in one of two ways:- o Standard worktop- Secure the d

41 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900

42

43

44 44

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before atte

6o Care should be taken not to trap the power supply cable underneath the appliance whilst installing it. o No attempt should be made to alter or

7Child Safety o Your dishwasher should only be used by adults. You should not allow children in the area of the machine unsupervised. You should no

8Specifications Product dimensions Height: 820 - 850 mm Width: 595 mm Depth: 560 mm Aperture dimensions Height: 820 mm (min) Width: 600 mm Dept

Electrical details Rated voltage: 230 Vac 50 Hz Supply connection: 13 A (double pole switched fused outlet with 3 mm contact gap) Optiona