Baumatic BHI631SS Manuel d'utilisateur

1 BHI631SS-AUS 60cm Front Touch Control Induction Cooktop

10Specifications Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 480 mm Width: 580 mm Width: 560 mm Height: 60 mm He

11Mains Supply Lead: 3 core x 6 mm² (not supplied) For future reference please record the following information which can be found on the rating p

12Control panel layout A) ON / OFF button B) Cooking zone plus button C) Cooking zone minus button D) Timer button Using the ceramic h

13Switching the hob on o When the hob is connected to a power supply all of the cooking zone indicators will come on for 1 second and then go off.

14o The zone will switch off immediately. o A flashing “H” symbol will show in the cooking zone indicator until the temperature of the zone falls

15Cookware that is suitable for an induction hob The table below shows cookware that is normally suitable for use on an induction zone hob:- Cookwa

16o You can set a count-down time between 1 – 99 minutes. An alarm will sound when this time is reached. Press any button to deactivate the alarm.

17o In addition, when the control panel detects an ambient temperature greater than 95°C it shuts off all the elements. A heating element that is sh

18Hob guidelines o The first few times the hob top is used, it may give off an acrid, burning smell. This smell will disappear completely with repe

19o DO NOT USE THE HOB IF THE SURFACE BECOMES BROKEN OR CRACKED. YOU SHOULD CONTACT THE BAUMATIC SERVICE DEPARTMENT IMMEDIATELY. Cleaning and maint

2User Manual for your Baumatic BHI631SS-AUS 60cm Touch Control Induction Cooktop NOTE: This User Instruction Manual conta

20discolourations cleaner Water splashes or water rings No Yes Ceramic hob cleaner Using a ceramic hob scraper A ceramic hob scraper will be provid

21Installation The installation must be carried out by a suitably qualified person, in accordance with the current version of the following. o AS/

22o You must make sure that there is a 5mm gap below the underneath of the worktop at the front edge of the hob. Unpacking the appliance When unpa

23o The heat produced by the oven, measured on the right side of the bottom of the hob, must be lower than 60°C, otherwise the heat could damage the

24 (A) Sealing strip (B) Clamp (C) Screw o Place the clamp (B) over the holes that match the size of the screws. There are one set of screw hole

25Electrical connection This appliance must be installed by a qualified person in accordance with the latest edition of the I.E.E. Regulations and i

26fully tightened between the links. This should be done before contacting the Service Department. o IMPORTANT: The appliance must NOT be connected

27My appliance isn’t working correctly o The cooking zones are not functioning or will not switch on. * The safety lock has been switched on (see

28Error codes The following error codes may appear in the timer display if there is a problem with the operation of the hob. Error code Description

29IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your mains supply and then contact the Servi

3

30 Think Appliances Pty Ltd. 416-424 Barry Rd Coolaroo VIC 3048 Sales Telephone 1300 132 824 Service Telephone 1800 444 357 Website www.thi

31

32

4Contents Environmental note 5 Important safety information 6 – 9 Specifications 10 – 12 Dimensions 10 Electrical details

5Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard

6Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before at

7Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch

8o IMPORTANT: This ceramic induction hob fully complies with current legislation regarding electro-magnetic interference and is designed not to inte

9Declaration of conformity This appliance complies with the following European Directives: -2006/95/CE General regulations / Low tension -1935/2004