Baumatic BHC635SS Manuel d'utilisateur télécharger pdf (Page 23)

Installing the appliance

o Cut a hole in the worktop that corresponds with the drawing

shown above.

o If the hob is being installed without an oven below it, a

separator panel must be placed between the bottom of the hob

and the housing below it, at a minimum distance of 10 mm.

o If the hob is being installed with an oven below it, place a

separator panel at a minimum distance of 15 mm and follow the

oven manufacturer’s instructions, ensuring that sufficient

aeration is provided.

o The heat produced by the oven, measured on the right side of

the bottom of the hob, must be lower than 60°C, otherwise the

heat could damage the touch control panel.

o IMPORTANT: You must observe the ventilation requirements

shown in the drawing below.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Pas de commentaire

Baumatic BHC635SS Manuel d'utilisateur Page 23