Baumatic cooker Manuel d'utilisateur

1BTI975GL 90 cm Glass island cooker hood

Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT YOU HAVE SWITCHED YOUR COOKER HOOD OFF AT THE OMNI-POLAR SWITCH, S

Maintenance Removing and cleaning the grease filters o First remove the grease filters by pulling down on the handle and pulling them aw

Changing a light bulb 12 IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR

o Use a screwdriver to remove the glass cover that sits over the bulb. Unplug the light bulb that needs to be replaced and insert a new G4 20W (max)

3) Insert the carbon filter in the rectangular hole, fitting it over the motor. IMPORTANT: The cutaway (indicated by the arrow) must be located a

Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated o

o As the colours of the wires in the appliance’s mains lead may not correspond with the coloured markings identifying the terminals in your spur box,

o Do not tile, grout or silicone this appliance to the ceiling. This appliance is designed to be surface mounted only. o Remove any protective wrap

IMPORTANT: Your ceiling should have a minimum height of 2.7 metres; otherwise you may encounter difficulties when installing the appliance. IMPORTA

Supplied installation components 1) Position the hanging plate on the ceiling and then mark the position of the screw holes. o The hanging plate

User Manual for your Baumatic BTI975GL Cooker Hood 90 cm Glass island cooker hood in stainless steel NOTE: This User In

2) Fix the angle bars to the hanging plate, using the 8 x M4 nuts and bolts with metal washers. 3) Extend the angle bars to the required

5) Fix the upper chimney section to the hanging plate, using the 4 x self tapping screws. o Slide the lower chimney section onto the angle bars and

8) If you are going to be using the hood in extraction mode, you should fix the ducting hose to the spigot. o The electrical connection must corre

o Refit the grease filters and then switch on the mains supply to the appliance. Check that the appliance is operating correctly by selecting each sp

Troubleshooting IMPORTANT: If your cooker hood appears not to be operating properly, before contacting Baumatic Customer Care, please refer to the ch

IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your mains supply and then contact Baumatic Cus

Czech Republic Baumatic CR spol s.r.o. United Kingdom Průmyslová zóna Sever 696 Baumatic Ltd., 460 11 Liberec 11 Baumatic Buildings, Czech Repu

28

3Contents Page Environmental note 4 IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood 8 Using your Baumat

ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before att

o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN

o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed

Specifications of your cooker hood Congratulations on purchasing a Baumatic cooker hood! PRODUCT DIMENSIONS Height: 660 mm

Using your cooker hood o Make sure that it has been installed by a suitably qualified person, as per the information contained in Baumatic’s instal