Baumatic B40 Manuel d'utilisateur

1el AS26SS/B26SS/B40/ B70.1BL/B71TCBL/ B72BL/B72TCBL/W/ B77BL/B77TCBL/B78BL/ PHG602 Gas hobs

10B70.1BL Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 480 mm Width: 580 mm Width: 560 mm Height: 50 mm Product speci

11B71TCBL Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 480 mm Width: 580 mm Width: 560 mm Height: 50 mm Product speci

12B72BL Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 490 mm Width: 580 mm Width: 560 mm Height: 50 mm o 1 x 3.50 kW

13B72TCBL/W Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 490 mm Width: 580 mm Width: 560 mm Height: 50 mm o 1 x 3.50

14B77BL Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 490 mm Width: 680 mm Width: 562 mm Height: 50 mm Product specifi

15B77TCBL Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 490 mm Width: 680 mm Width: 562 mm Height: 50 mm Product speci

16B78BL Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 490 mm Width: 680 mm Width: 562 mm Height: 50 mm Product specifi

17PHG602 Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 490 mm Width: 580 mm Width: 560 mm Height: 50 mm

18Electrical details Rated Voltage: 230 Vac 50 Hz Supply Connection: 3 A (double pole switched fused outlet with 3mm contact gap) Max Rated Input

19B40 A = 3.50 kW wok burner B = 3.00 kW rapid burner C = 1.75 kW semi-rapid burner D = Control panel B70.1BL/B71TCBL

2User Manual for your Baumatic AS26SS 90 cm 4 Burner gas glass hob with thermocouples B26SS 90 cm 4 Burner gas glass hob with thermocouples B40 Circ

20B77BL/B77TCBL/B78BL Using the gas hob Before first use IMPORTANT: You should clean the hob surface (see “Cleaning and maintenance”

21o The symbol on the control panel, next to the control knob will indicate which gas burner it operates. Automatic ignition with flame failure saf

22Energy saving tips PANS BURNERS Minimum diametre Maximum diametre Wok 220 mm 260 mm Rapid 180 mm 220 mm Semi-rapid 120 mm 200 mm Auxiliary

23Cleaning Cleaning operations must only be carried out when the hob is cool. The appliance should be disconnected from your mains supply before co

24o Before placing the burners back on the hob top, make sure that the gas jet is not blocked. o IMPORTANT: Make sure that you reassemble the burn

25Positioning The adjacent furniture must be able to withstand a minimum temperature rise of 85°C above the ambient temperature of the room it is lo

26o 50 mm clearance around the appliance and between the hob surface and any combustible materials. Unpacking the appliance When unpacking the app

27B70.1BL B71TCBL B72BL B72TCBL/W PHG602 B77BL B77TCBL B78BL o Cut a hole in the worktop that corresponds with the

28o IMPORTANT: You must have a gap of at least 25 mm between the underneath of the appliance and any surface that is below it. o Carefully

29o Carefully turn the hob back over and then gently lower it into the aperture hole that you have cut out. o On the underneath of the hob, adjust

3Contents Environmental note 4 Important safety information 5 – 7 Specifications 8 – 20 AS26SS/B26SS 8 B40 9 B70.

30o If the room has a volume of less than 5m³, it will require an air vent of 100cm² (effective area). o If it is installed in a room with a volum

31 o Put the gas seal into the elbow. o Fully tighten the elbow and seal onto the gas rail. o The elbow MUST be pointing in a downward

32 A = Gas inlet B = Seals C = Gas Elbow D = Copper pipe (not supplied) o Put the gas seal into the elbow. o Fully tighten the elbow a

33 o Unscrew the injector (B) and replace it with the stipulated injector for the new gas supply (see table below). GENERAL INJECTORS TABLE

34Minimum flow adjustment for hob gas taps. All work must be carried out by a GASSAFE registered engineer. IMPORTANT: Always isolate the hob from

35Gas tap maintenance These maintenance operations MUST ONLY be carried out by a GASSAFE registered engineer. IMPORTANT: Before carrying out any ma

36o Reconnect the gas tap, perform a gas soundness test and then reassemble the hob. Electrical connection This appliance must be installed by a q

37My appliance isn’t working correctly IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your m

38 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales

39

4Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard

40

5Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before at

6Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch

7Cleaning o Cleaning of the hob should be carried out on a regular basis. o IMPORTANT: Before attempting to clean the appliance, it should be di

8Specifications AS26SS/B26SS Product dimensions: Aperture dimensions: Height: 350 mm Height: 335 mm Width: 880 mm Width: 865 mm Depth:

9B40 Product dimensions: Aperture dimensions: Width: 520 mm Width: 500 mm Height: 50 mm Product specifications: o 1 x 3